Pinnacle™ 20 kW
Figure 4-2. DeviceNet
Installation
Refer to the following pin descriptions when connecting to the DeviceNet port. Use
the appropriate female, micro connector and cable. See the DeviceNet Specification
(revision 2.0) from the Open DeviceNet Vendor Association, Inc. for specifics on the
mating connector and cable. Use the rotary switches to select a baud rate and set the
unit address (MAC ID).
PIN DESCRIPTIONS
This table lists the pin numbers and DeviceNet pin names. See the DeviceNet
Specification (revision 2.0) for definitions of these pin names.
Table 4-2. DeviceNet
Pin Number
1
2
3
4
5
ROTARY SWITCHES: BAUD RATE AND ADDRESSING
The DeviceNet interface features three rotary switches, located on the rear of the
Pinnacle unit, which are read each time the DeviceNet interface powers up (see Figure
4-3).
5702156-E
™
port with pin designations
™
Pin Descriptions
Pin Name
Drain
V+
V-
CAN_H
CAN_L
I/O Communication and Control
4-5