Setting Ripple Level - Advanced Energy Pinnacle User Manual

20 kw (325-650 vdc) devicenet, ae bus, mdxl user, terminal block output

Table of Contents

Advanced Energy

1. After you have entered a value from 1 through 8 at the # OF STEPS screen (see

steps 1 through 2 above), you should be looking at a screen that requests a RAMP

TIMER value.

2. Rotate the MODIFY knob to select a value between 0.05 s to 600 s (in 0.01 s

increments).

3. Press ENTER; the display progresses to a screen requesting a SETPOINT value.

4. Use the REGULATION key to toggle between power, current and voltage. Use

the MODIFY knob to select a value between 0 and the full rated output of the

supply.

5. Press ENTER; the display progresses to a screen requesting a RUN TIMER value.

6. Rotate the MODIFY knob to select a value between 0.00 s to 600 s (in 0.01 s

increments).

Note: If your unit has the 100 ms ramp feature, the range is 0 s to 6000.0 s.

7. If you are turning the MODIFY knob slowly, press the appropriate soft key to

indicate how quickly you want the display to increment the value (x10 or x1).

Note: If you turn the MODIFY knob quickly, the counts per click setting takes

8. Press ENTER; if you have indicated that your recipe contains more than one step,

the display returns to the RAMP TIMER screen so that you can enter recipe values

for the next step.

9. Repeat Steps 2 through 7 as needed.

Note: If you assign 0 run time for the final recipe step, the unit will switch to

continuous output when it reaches setpoint for this step. In this situation, to turn

off output, you must send an off command (using the OFF button or the

appropriate User port signal or serial port command) or you must have already

programmed a joules setpoint.

Note: The setpoint source must be set to internal to run a recipe. See "Setting the

Program Source" on page 4-29 for more information.