Detailed Settings; Gray Adjustment; Setting The Color Calibration Cycle - Kyocera TASKalfa 250ci Service Manual

Detailed Settings

1. Press cursor down key and then [Next] of Color
Registration.
2. Press [Detail].
3. Press [Print] of Chart (Details). A chart is printed.
On the chart, for each of M (magenta), C (cyan)
and Y (yellow), charts for H-1 to 7 and V-3 are
printed.
4. Find the location on each chart where 2 lines most
closely match. If this is the 0 position, registration
for that color is not required. For the illustration, B is
the appropriate value.
From charts V-1 to V-5, read only the values from
V-3 (center).
5. Press [Next] of Registration (Details).
6. Press [Change] for the chart to be corrected.
7. Press [+] or [-] to enter the values read from the
chart and press [OK].
Press [+] to increase the value from 0 to 9. To
decrease, press [-].
By pressing [-], the value changes from 0 to alpha-
betic letters, going from A to I. To move in the
reverse direction, press [+].
You cannot use the numeric keys to enter these
values.
8. Repeat steps 6 and 7 to enter the registration val-
ues for each chart.
9. Press [Execute] after all values have been entered.
Color registration begins.
10. Press [OK] after color registration is complete.

Setting the Color Calibration Cycle

1. Press cursor down key and then [Change] of Color
Calibration Cycle.
2. Select [Auto], [Short], [Standard] or [Long].
3. Press [OK].

Gray Adjustment

Normal adjustment
1. Press cursor down key and then [Next] of Gray
Adjustment.
2. Press [Execute]. A color pattern is printed.
Check that the number "1" and one magenta box
are printed in the top right corner of the color pat-
tern.
3. As shown in the illustration, place the printed side
down on the platen with the three black boxes
aligned to the top.
4. Press the Start key. The color pattern is read and
adjustment begins.
5. The second color pattern is output. Check that the
number "2" and two magenta boxes are printed in
the top right corner of the color pattern and then
repeat steps 3 and 4.
6. Press [OK] in the adjustment end confirmation
screen.
Detailed Adjustment
1. Press cursor down key and then [Next] of Gray
Adjustment.
2. Press [Detail].
3. Press [Execute]. A color pattern is printed.
Check that the number "1" and one magenta box
are printed in the top right corner of the color pat-
tern.
4. As shown in the illustration, place the printed side
down on the platen with the three black boxes
aligned to the top.
5. Press the Start key. The color pattern is read and
adjustment begins.
2JZ/2JX/2JV/2H7-1
1-3-149