Kyocera TASKalfa 250ci Service Manual page 139

Maintenance
item No.
Setting: [TURNED STAPLE HP ADJ]
U246
1. Change the setting value using the +/- or numeric keys.
Description
Adjustment of slanted stapling home position
To increase the angle for slanted stapling (sample 1), decrease the preset value. To decrease the angle
for slanted stapling (sample 2), increase the preset value.
2. Press the start key. The value is set.
Method: [BOOKLET FOLDER]
1. Select the item to set. The screen for setting each item is displayed.
Display
WIDTH U HP ADJ
WIDTH L HP ADJ
STAPLE POS ADJ (A4R/LTR)
STAPLE POS ADJ (B4R/LGR)
STAPLE POS ADJ (A3/LD)
SADDLE POS ADJ (A4R/LTR)
SADDLE POS ADJ (B4R/LGR) Adjustment of center folding position for B4/Legal size
SADDLE POS ADJ (A3/LD)
Setting: [WIDTH U HP ADJ/WIDTH L HP ADJ]
1. Select [WIDTH U HP ADJ] or [WIDTH L HP ADJ].
2. Change the setting value using the +/- or numeric keys.
Description
Adjustment of upper side registration home position
Adjustment of lower side registration home position
3. Press the start key. The value is set.
4. Press the stop key. The screen for selecting a maintenance item No. is displayed.
5. Enter maintenance mode U240 and select [BOOKLET], then [WID A3 TEST].
The width guides of the center-folding unit will move to A3-size position.
6. Pull the center-folding unit, insert paper between the guides and check that paper is abut the guides.
7. Repeat the above adjustment until paper is properly in position.
Description
Setting
range
-10 to 10
Sample 1
Figure 1-3-19
Description
Adjustment of upper side registration home position
Adjustment of lower side registration home position
Adjustment of booklet stapling position for A4/Letter size
Adjustment of booklet stapling position for B4/Legal size
Adjustment of booklet stapling position for A3/Ledger size
Adjustment of center folding position for A4/Letter size
Adjustment of center folding position for A3/Ledger size
Setting
range
-20 to 20
-46 to 46
2JZ/2JX/2JV/2H7
Initial Change in
setting value per step
°
0
0.99
Sample 2
Initial Change in
setting value per step
0 0.104 mm
0 0.104 mm
1-3-95