Kyocera TASKalfa 250ci Service Manual page 218

2JZ/2JX/2JV/2H7
Problem
(20)
A paper jam in the
fuser section is indi-
cated during copying
(misfeed in fuser sec-
tion).
Jam code 40 to 46
(21)
A paper jam in the
eject section is indi-
cated during copying
(misfeed in eject sec-
tion).
Jam code 50
(22)
A paper jam in the
eject section is indi-
cated during copying
(misfeed in job sepa-
rator eject section).
Jam code 51
(23)
A paper jam in the
feedshift section is
indicated during
copying (misfeed in
feedshift section).
Jam code 52
(24)
A paper jam in the
duplex section is indi-
cated during copying
(misfeed in duplex
paper conveying sec-
tion 1).
Jam code 60
(25)
A paper jam in the
duplex section is indi-
cated during copying
(misfeed in duplex
paper conveying sec-
tion 2).
Jam code 61
1-4-18
Causes/check procedures
Broken eject switch actua-
tor.
Defective switch.
Broken eject switch actua-
tor.
Defective switch.
Broken switch actuator.
Defective switch.
Broken feedshift switch
actuator.
Defective feedshift switch.
Broken switch actuator.
Defective switch.
Broken registration switch
actuator.
Defective registration
switch.
Defective registration
clutch.
Electrical problem with reg-
istration clutch.
Corrective measures
Check visually and replace switch.
Run maintenance item U031 and turn the following switch on and
off manually. Replace the switch if indication of the corresponding
switch on the touch panel is not displayed in reverse.
Loop sensor, eject switch
Check visually and replace switch.
Run maintenance item U031 and turn the following switch on and
off manually. Replace the switch if indication of the corresponding
switch on the touch panel is not displayed in reverse.
Loop sensor, eject switch
Check visually and replace switch.
Run maintenance item U031 and turn the following switch on and
off manually. Replace the switch if indication of the corresponding
switch on the touch panel is not displayed in reverse.
Eject switch, job eject switch, finisher eject switch
Check visually and replace switch.
Run maintenance item U031 and turn the feedshift switch on and
off manually. Replace the switch if indication of the corresponding
switch on the touch panel is not displayed in reverse.
Check visually and replace switch.
Run maintenance item U031 and turn the following switch on and
off manually. Replace the switch if indication of the corresponding
switch on the touch panel is not displayed in reverse.
Feedshift switch, duplex switch, registration switch
Check visually and replace switch.
Run maintenance item U031 and turn the registration switch on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U032 and select registration clutch on the
touch panel to be turned on and off. Check the status and remedy
if necessary.
Check (see page 1-4-71).