Kyocera TASKalfa 250ci Service Manual page 296

2JZ/2JX/2JV/2H7-1
Refitting the ISU
5. Adjust the position of ISU to the frame hole
of number and the same number which are
recorded in the lens of ISU and then insert
two positioning pins.
Example: When a lens number is 5, move
ISU so that the positioning hole of 5 of the
number stamped in the scanner unit suit and
insert two pins.
6. Remove two positioning pins after fixing ISU
with three screws.
7. Refit two connectors.
8. Refit the ISU cover.
Screw tightening order
1) Three screws A
2) Four screws B
9. Refit the contact glass.
1-5-20
Positioning pin
Positioning hole
Lens number
Figure 1-5-33
Screws B
ISU cover
Connector
Figure 1-5-34
ISU
Positioning hole
Screws A
Screws B
Connector