Kyocera TASKalfa 250ci Service Manual page 316

2JZ/2JX/2JV/2H7-1
5. Remove the cut washer, bearing, stop ring,
gear, pin, transfer stopper, transfer bush and
argent transfer spring from the transfer roller
rear.
Remove the cut washer, bearing, transfer
stopper, transfer bus and black transfer
spring from the transfer roller front.
6. Check or replace the transfer roller and refit
all the removed parts.
7. Push in the left transfer guide to refit the
guide in position.
Caution in refitting left transfer guide
The ground terminal and the varistor termi-
nal must be tightened together with a screw.
Make sure that the two springs on the left
transfer guide are caught with the protru-
sions on the paper conveying unit.
8. When the transfer roller is replaced with a
new one, carry out the following procedure.
9. Perform maintenance mode U127 (clearing
the trasfer counter) (see page 1-3-64).
10. Perform the following image adjustment.
1)Color Calibration
2)Color Registration
3)Maintenance mode U412 (adjusting the
uneven density) (see page 1-3-114).
4)Maintenance mode U410 (Adjusting the
halftone automatically) (see page 1-3-
110).
1-5-40
Transfer roller
Transfer
stopper
Cut
washer
Transfer bush
Bearing
Transfer
spring (black)
Transfer roller
Stop ring
Pin
Transfer
stopper
Gear
Transfer bush
Transfer spring (argent)
Figure 1-5-67
Left transfer guide
Screw
Ground terminal
Spring
Varistor terminal
Left transfer
Ground terminal
guide
Figure 1-5-68
Cut
washer
Bearing
Spring
Screw