Detaching And Refitting The Transfer Roller - Kyocera TASKalfa 250ci Service Manual

(2) Detaching and refitting the transfer roller

Follow the procedure below to replace the transfer roller.
Procedure
1. Open left cover 1.
2. Using a flat-blade screwdriver, remove the
left transfer guide by prying the protrusion
off the hole.
3. Remove the screw and then remove the
ground terminal and varistor terminal.
4. Remove the transfer roller while pressing
down the transfer stopper of both ends.
Protrusion
Left transfer guide
Figure 1-5-65
Transfer roller
Transfer
stopper
Figure 1-5-66
2JZ/2JX/2JV/2H7-1
flat-blade
screwdriver
Left cover 1
Screw
Ground terminal
Varistor terminal
Left transfer Ground terminal
guide
Screw
Transfer
stopper
1-5-39