Detaching And Refitting The Charger Roller Unit - Kyocera TASKalfa 250ci Service Manual

Hide thumbs Also See for TASKalfa 250ci:

Table of Contents

2JZ/2JX/2JV/2H7

(4) Detaching and refitting the charger roller unit

Follow the procedure below to replace the charger roller unit.

Example of detaching and refitting: charger roller unit Y

1. Remove the image formation holder (see

page 1-5-30).

2. Remove the screw and then remove the

charger roller unit Y.

3. Check or replace the charger roller unit Y

and refit all the removed parts.

4. When the charger roller unit is replaced with

a new one, carry out the following proce-

5. Perform maintenance mode U930 (clearing

the charger roller count) (see page 1-3-138).

Charger roller unit Y

Figure 1-5-62

Show Quick Links

Table of Contents

Taskalfa 300ci Taskalfa 500ci Taskalfa 400ci