BinTec RS353j User Manual page 542

Rs series
Hide thumbs Also See for RS353j:
Table of Contents

Advertisement

Glossary
528
AUX
AUX is a signal input for external devices, e. g. analogue or GSM
modems.
B channel
See Basic Rate Interface and Primary Rate Interface.
Back Route Verify
If a Back Route Verify is activated for an interface, incoming data
packets are only accepted over this interface if outgoing response
packets are routed over the same interface.
Backbone area
The core area of a network which connects all the sub-networks
(areas) with one another is known as the backbone.
Basic Rate Interface
The Basic Rate Interface is a network connection to the ISDN. This
type of connection is often abbreviated to BRI. A basic rate interface
includes two basic channels (B channels) each with 64 kbps and
one control and signalling channel (D channel) with 16 kbps. There
are two operating modes for the Basic Rate Interface: Point-to-point
ISDN and Point-to-multipoint The Primary Rate Interface (PRI) is
used with larger installations.
Beacon
The central access point sends beacons to create a wireless LAN in
infrastructure mode. These messages contain the network name
(SSID), a list of the supported transmission rates and the type of en-
cryption.
Bit
A binary digit (bit) is the smallest unit of data in computing techno-
logy. Signals are represented in the logical states "0" and "1".
Black / White List
Entries in the Black List are blocked, entries in the White List are al-
lowed through. (Example: Any telephone number beginning with
01234 is blocked in the Black List. The number 01234987 can non-
etheless be approved in the White List.)
Blowfish
Blowfish is an encryption method (see Cipher). Blowfish uses a fixed
block length of 64 bits. The key length can be between 32 and 448
bits.
BootP
The Bootstrap Protocol (BootP) is used to automatically issue an IP
address.
Bps
Bits per second. A unit of measure for the transmission rate.
BRI
See Basic Rate Interface
Bridge
A bridge is a network component for connecting the same types of
network at Level 2 of the OSI model. Data packets are transmitted
using MAC addresses. The use of bridges divides up the network
bintec elmeg GmbH
bintec RS Series

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rs353j-4gRs353jw

Table of Contents