BinTec RS353j User Manual page 149

bintec elmeg GmbH
bintec RS Series
Field
VLAN ID
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field
DHCP MAC Address
DHCP Hostname
DHCP Broadcast Flag
Description
Use built-in is activated by default.
Only for Interface Mode =
This option only applies for routing interfaces. Assign the inter-
face to a VLAN by entering the VLAN ID of the relevant VLAN.
Possible values are (default value) to
Description
Only for Address Mode =
If Use built-in is activated (default setting), the hardware MAC
address of the Ethernet interface is used. In the case of physical
interfaces, the current MAC address is entered by default.
If you disable Use built-in, you enter an MAC address for the
virtual interface, e.g.
Some providers use hardware-independent MAC addresses to
allocate their clients IP addresses dynamically. If your provider
has assigned you a MAC address, enter this here.
Only for Address Mode =
Enter the host name requested by the provider. The maximum
length of the entry is 45 characters.
Only for Address Mode =
Choose whether or not the BROADCAST bit is set in the DHCP
requests for your device. Some DHCP servers that assign IP
addresses by UNICAST do not respond to DHCP requests with
the set BROADCAST bit. In this case, it is necessary to send
DHCP requests in which this bit is not set. In this case, disable
this option.
The function is activated by selecting
The function is enabled by default.
9 LAN
.
.
.
135