Table of Contents
Advertisement
bintec elmeg GmbH
bintec RS Series
Field
Weight
RTT Mode (Realtime
Traffic Mode)
Traffic Shaping
Maximum Upload
Speed
Overbooking allowed
Description
Choose the priority of the queue. Possible values are
priority) to
(low priority).
The default value is .
Only for Prioritisation Algorithm =
or
Choose the priority of the queue. Possible values are
The default value is .
Active or deactivate the real time transmission of the data.
The function is enabled with
The function is disabled by default.
RTT mode should be activated for QoS classes in which real
time data has priority. This mode improves latency when for-
warding real time datagrams.
It is possible to configure multiple queues when RTT mode is
enabled. Queues with enabled RTT mode must always have a
higher priority than queues with disabled RTT mode.
Activate or deactivate data rate (=Traffic Shaping) limiting in the
send direction.
The data rate limit applies to the selected queue. (This is not the
limit that can be defined on the interface.)
The function is enabled with
The function is disabled by default.
Only for Traffic Shaping = enabled.
Enter a maximum data rate for the queue in kbits.
Possible values are
to
The default value is .
Only for Traffic Shaping = enabled.
12 Networking
(high
to
.
.
.
.
245
Hide quick links:
Advertisement
Table of Contents
