Table of Contents
Advertisement
bintec elmeg GmbH
bintec RS Series
Fields in the Advanced Settings menu.
Field
Alive Check
Description
Only for Phase-1 (IKE) Parameters
Select the method to be used to check the functionality of the
IPSec connection.
In addition to the default method Dead Peer Detection (DPD),
the (proprietary) Heartbeat method is implemented. This sends
and receives signals every 5 seconds, depending on the config-
uration. If these signals are not received after 20 seconds, the
SA is discarded as invalid.
Possible values:
•
(default value): Your device detects and uses
the mode supported by the remote terminal.
•
: Your device sends and expects no heartbeat. Set
this option if you use devices from other manufacturers.
•
heartbeat from the peer but does not send one itself.
•
beat from the peer, but sends one itself.
•
heartbeat from the peer and sends one itself.
•
accordance with RFC 3706. DPD uses a request-reply pro-
tocol to check the availability of the remote terminal and can
be configured independently on both sides. This option only
checks the availability of the peer if data is to be sent to it.
•
tection) in accordance with RFC 3706. DPD uses a request-
reply protocol to check the availability of the remote terminal
and can be configured independently on both sides. This op-
tion is used to carry out a check at certain intervals depending
on forthcoming data transfers.
Only for Phase-1 (IKEv2) Parameters
Enable or disable alive check.
The function is enabled by default.
: Your device expects a
: Your device expects no heart-
: Your device expects a
: Use DPD (dead peer detection) in
: Use DPD (dead peer de-
16 VPN
347
Hide quick links:
Advertisement
Table of Contents
