BinTec RS353j User Manual page 238

12 Networking
224
Field
Destination Port/Range Only for Type of traffic =
In the NAT Configuration ->Replacement Values menu you can define, depending on
whether you're dealing with inbound or outbound data traffic, new addresses and ports, to
which specific addresses and ports from the NAT Configuration ->Specify original traffic
menu can be translated.
Fields in the menu Replacement Values
Field
New Destination IP Ad-
dress/Netmask
New Destination Port
New Source IP Ad-
dress/Netmask
New Source Port
Description
method = , Service =
tocol = , ,
, Service =
, ,
Enter the destination port or the destination port range of the
original data packets. The default setting
port remains unspecified.
Description
Only for Type of traffic =
Enter the destination IP address and corresponding netmask to
which the original destination IP address is to be translated.
Only for Type of traffic =
Service =
Leave the destination port as it appears or enter the destination
port to which the original destination port is to be translated.
Select to leave the original destination port. If you
disable , an input field appears and you can enter a
new destination port.
is active by default.
Only for Type of traffic =
method =
Enter the source IP address to which the original source IP ad-
dress is to be translated, with corresponding netmask, as the
case arises.
Only for Type of traffic =
method = , Service =
bintec elmeg GmbH
and Pro-
or Type of traffic =
and Protocol =
means that the
and Protocol = , ,
and Pro-
, NAT
,
and NAT
, NAT
bintec RS Series