Table of Contents
Advertisement
12 Networking
220
Field
Interface
Type of traffic
NAT method
Description
Select the interface for which NAT is to be configured.
Possible values:
•
(default value): NAT is configured for all interfaces.
•
: Select one of the interfaces from the
list.
Select the type of data traffic for which NAT is to be configured.
Possible values:
•
traffic that comes from outside.
•
•
NAT.
Only for Type of traffic =
Select the NAT method for outgoing data traffic. The starting
point for choosing the NAT method is a NAT scenario in which
an "internal" source host has initiated an IP connection to an "ex-
ternal" destination host over the NAT interface, and in which an
internally valid source address and internally valid source port
are translated to an externally valid source address and an ex-
ternally valid source port.
Possible values:
•
(UDP only): Any given external host may send IP
packets via the external address and the external port to the
initiating source address and the initial source port.
•
(UDP only): Like full-cone NAT; as ex-
ternal host, however, only the initial "external" destination host
is allowed.
•
NAT; however, exclusively data from the initial destination
port are allowed.
•
(standard value) any protocol: Outbound, an ex-
ternally valid source address and an externally valid source
port are administratively set. Inbound, only response packets
bintec elmeg GmbH
(default value): The data
: Outgoing data traffic.
: Data traffic excluded from
(UDP only): Like restricted-cone
bintec RS Series
Hide quick links:
Advertisement
Table of Contents
