BinTec RS353j User Manual page 247

bintec elmeg GmbH
bintec RS Series
Field
Source Port/Range
Special Handling Timer Enter the time period during which the specified data packets
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field
Frozen Parameters
Description
• : Enter the network address and the related net-
mask.
Enter, if required, a source port number or a range of source
port numbers.
Possible values:
• (default value): The destination port is not specified.
• : Enter a destination port.
•
are to be routed via the route that has been defined.
The default value is seconds.
Description
Specify whether, when data packets are subsequently sent, the
two parameters Destination Address and Destination Port
must have the same value as the first data packet, i. e. whether
the subsequent data packets must be routed via the same Des-
tination Port to the same Destination Address.
The two parameters Destination Address and Destination
Port are enabled by default.
If you leave the default setting
meters, the value of the parameter concerned must be the
same as in the first data packet with data packets sent sub-
sequently.
You can disable one or both parameters if you wish.
The Source IP Address parameter must always have the same
value in data packets sent subsequently as it did in the first data
packet. So it cannot be disabled.
: Enter a destination port range.
for one or both para-
12 Networking
233