How To Program An Address Into The Rcu; Input Selection - Barco R9002410 Owner's Manual

How to program an address into the RCU

To continue using the RCU, it is necessary to enter the address shown in the 'Text Box' with the digit keys on the RCU.
For example, if the displayed address is ' 003 '. press 3 on the RCU.

Input selection

Source No Projector input
1 Comp. Video
2 S-Video
3 Tuner
4 RGsB
5 RGBs
6 YUV
Two possible ways of selecting an input :
a. with the digit keys on the RCU
b. with the local keypad
Press first the ADJUST key to display the GENERAL ACCESS menu.
Use the control keys to highlight the desired number.
Press ENTER to confirm your selection.
When a a valid and connected source is selected, information about that source will be displayed in a 'Text Box' on the screen.
This information includes :
- Source Number
- Horizontal scan rate
- Vertical scan rate
When the entry is an invalid source number, a warning appears on screen
Input not available
When a valid source number is selected, the projector will display this source or it will wait until the source becomes available.
A message Source not available will be displayed for a short time.
R5976101 BARCO CINE 5 ___________________________________________________________________________________
Press digit
1
2
4
5
6
Controlling
Source 2
Fh = 15.6 khz
Fv = 60 hz
Warning
Input not
available
Warning
source not
available
4-3