How To Program An Address Into The Rcu; Input Selection; Analog Picture Controls - Barco Graphics 808s Owner's Manual

How to program an address into the RCU?

Press the ADDRESS key (recessed key on the RCU) with a pencil
and enter the address with the digit buttons. That address can be
any digit between 0 and 9.
When programming '0', zero address, the RCU will control a projector
regardless of the projector's address. This feature allows multiple
projectors with different addresses to be controlled by a single RCU.

Input selection

Port No Projector input
1 Comp. Video
2 S-Video /Comp. Video*
1
3 RGB
2
4/5 RGB
2
4/5 Component video
4/5 RGB with Tri level sync
4/5 Component video
with Tri-level sync
Only available when the optional Tri-level sync module is
installed.
Input signal Y/C (luma/chroma)
1
Input signal : R, G and B with automatic sync detection between
2
seperate sync (separate composite sync or with separate Hor
and Vert. sync) or sync on green (composite sync).
Input signal : R-Y, Y and B-Y with separate
3
or with separate Hor and Vert. sync or with composite sync on
Y.
Input signal : R, G and B with separate Tri level sync or with Tri-
4
level sync on green.
Input signal : R-Y, Y and B-Y with separate Tri level sync or with
5
composite Tri-level sync.
* Video or S-Video : switchable in the Picture Tuning menu.
With the digit buttons on the RCU, it is possible to select input sources,
Video, S-Video, RGsB or RGBS, RG3sB or RGB3S.
When a valid and available source is selected, there will be informa-
tion displayed on the screen about that source (if "Text" is on). This
information includes :
- Source number
- Horizontal frequency
- Vertical frequency
5976283 BARCOGRAPHICS 808s 160501
All manuals and user guides at all-guides.com
Press Digit
Button
1
2
3
4 or 5
6
3
7
4
8
5
composite sync
When the entry is a non valid source
number, a warning appears on the screen : 'input not available'.
When a valid source number is selected, the projector will display this
source or it will wait on the selected source number until the source
becomes available. A message 'source not available' will be
displayed for a short time.

Analog Picture Controls

The analog picture controls can be adjusted with the RCU. The control
keys are located on the lower right side of the key panel of the RCU
and indicated with the name of the control and an icon.
When an analog picture control is pressed, a text box with bar scale
and the function name of the control, e.g. 'brightness...' appears on
the screen (only if 'TEXT' is ON). The length of the bar scale indicates
the current memorized setting for this source. The bar scale changes
as the + or - buttons of the control are pressed.
Brightness Control
A correct 'brightness' setting is important for good image reproduc-
tion. Adjust the brightness with the + or - button (RCU) until the darkest
parts of the picture appear black.
A bar scale gives a visual indication on the screen of the current
brightness setting while pressing on the above indicated keys. If the
bar scale is not visible on the screen, press 'TEXT' key once and retry
the above indicated keys.
Controlling
WARNING
INPUT NOT
AVAILABLE
WARNING
SOURCE NOT
AVAILABLE
BRIGHTNESS
35
4-3