How To Display A Projector Address; How To Program An Address Into The Rcu; Picture Controls With Direct Access - Barco BARCOVISION 8100 Owner's Manual

CONTROLLING

HOW TO DISPLAY A PROJECTOR ADDRESS?

Press the ADDRESS key (sunk key on
the RCU) with a pencil. The projector's
address will be displayed in a 'Text
box'. This text box disappears after a
few seconds.
To continue using your RCU, it is nec-
essary to enter an address with the digit
buttons (address between 0 and 9).

HOW TO PROGRAM AN ADDRESS INTO THE RCU?

Press the ADDRESS key (sunk key on the RCU) with a pencil and enter the address
with the digit buttons. That address can be any digit between 0 and 9.
When programming '0', zero address, the RCU will control any projector regardless
of the projector's address. This feature allows multiple projectors with different
addresses to be controlled by a single RCU.

PICTURE CONTROLS WITH DIRECT ACCESS.

When an image control is pressed, a
text box with a bar scale, icon and
function name of the control, e.g. 'bright-
ness...' appears on the screen (only if
text is ON). See example screen. The
length of the bar scale indicates the
current memorized setting for this
source. The bar scale changes as the
+ or - buttons of the control are pressed.
The picture controls can be adjusted
with the RCU and the local keypad.
Brightness Control
A correct 'brightness' setting is important for good image reproduction.
Use the + button for a higher brightness.
Use the - button for a lower brightness.
Contrast Control
A correct 'contrast' setting is important for good image reproduction.
Adjust the contrast to the level you prefer, according to room lighting conditions.
Use the + button for a higher contrast.
Use the - button for lower contrast.
5975617 BARCOVISION 8100 150197
Projector address
001
Brightness
0.......10.......20.......30........40.......50.......60
8-5
CONTROLLING
HOW TO DISPLAY A PROJECTOR ADDRESS?
Press the ADDRESS key (sunk key on
the RCU) with a pencil. The projector's
address will be displayed in a 'Text
box'. This text box disappears after a
few seconds.
To continue using your RCU, it is nec-
essary to enter an address with the digit
buttons (address between 0 and 9).
HOW TO PROGRAM AN ADDRESS INTO THE RCU?
Press the ADDRESS key (sunk key on the RCU) with a pencil and enter the address
with the digit buttons. That address can be any digit between 0 and 9.
When programming '0', zero address, the RCU will control any projector regardless
of the projector's address. This feature allows multiple projectors with different
addresses to be controlled by a single RCU.
PICTURE CONTROLS WITH DIRECT ACCESS.
When an image control is pressed, a
text box with a bar scale, icon and
function name of the control, e.g. 'bright-
ness...' appears on the screen (only if
text is ON). See example screen. The
length of the bar scale indicates the
current memorized setting for this
source. The bar scale changes as the
+ or - buttons of the control are pressed.
The picture controls can be adjusted
with the RCU and the local keypad.
Brightness Control
A correct 'brightness' setting is important for good image reproduction.
Use the + button for a higher brightness.
Use the - button for a lower brightness.
Contrast Control
A correct 'contrast' setting is important for good image reproduction.
Adjust the contrast to the level you prefer, according to room lighting conditions.
Use the + button for a higher contrast.
Use the - button for lower contrast.
5975617 BARCOVISION 8100 150197
Projector address
001
Brightness
0.......10.......20.......30........40.......50.......60
8-5