Table of Contents
Advertisement
6.3 Projector address
The projector's address may be set to any value between 0 and 255 (see 'Change projector address'
in chapter 'Service mode). When the address is set, the projector can be controlled now by the
for addresses between 0 and 9.
The projector can also be controlled by computer, e.g. IBM PC (or compatible), Apple MAC, etc.
for addresses between 0 and 255.
A projector will respond to a
is set in the projector itself.
6.3.1 Using the RCU
The
is default programmed with address 0,
RCU
grammed into the RCU, every projector, without exception will listen to the commands given by
this
. If it is necessary to control a specific projector, than enter the projector address into the
RCU
(only when that address is between 0 and 9). The projector with the corresponding address
RCU
will listen to that specific
6.3.2 Displaying a Projector Addre ss
Press the
ADDRESS
displayed in a 'Text box'. This text box disappears after a few seconds.
To continue using the
the
(address between 0 and 9) within 5 seconds after pushing the address key. For
digit buttons
example if the
Address
to set the
's address to match the projector's address. Do not press 003 digits. This will address
RCU
the remote control to '0' and control all projectors in the room.
If the address is not entered within 5 seconds, the
and control all projectors in the room.
6.3.3 How to Program an Address into the RCU?
Press the
ADDRESS
digit buttons within 5 seconds after pushing the
tween 0 and 9.
6.3.4 Picture Controls with Direct A ccess.
When an image control is pressed, a text box with a bar scale, icon and function name of the con-
trol, e.g. 'brightness...' appears on the screen (only if
the value of the numeric indication indicate the current memorized setting for this source. The bar
scale changes as the control stick on the
Brightness Control
A correct
'brightness'
Use the
button for a higher brightness.
+
Use the
button for a lower brightness.
-
Contrast Control
A correct
setting is important for good image reproduction.
'contrast'
Adjust the contrast to the level you prefer, according to room lighting conditions.
Use the
button for a higher contrast.
+
Use the
button for lower contrast.
-
R5976255 A
CS4 (2001-03)
TLAS
RCU
.
RCU
key (recessed key on the
with that specific address, it is necessary to enter the same address with
RCU
key displays projector address 003, then press "3" digit button on the
key (recessed key on the
RCU
setting is important for good image reproduction.
set to an address of '0' regardless of what address
. With that
'zero address'
) with a pencil. The projector's address will be
RCU
returns to its default address (
RCU
) with a pencil and enter the address with the
RCU
key. That address can be any digit be-
address
is
). The length of the bar scale and
TEXT
ON
is pressed or the
or
buttons on the local
+
-
RCU
pro-
'zero address'
RCU
)
zero address
.
keypad
6-19
Advertisement
Table of Contents
