Power Down The Projector; Power Mode Transitions; General - Barco F70 Series User Manual

Getting started
Power up the projector using the keypad or remote
1. Connect the line cord to the projector.
2. Plug the 3–pronged cord into a grounded AC outlet.
The projector will begin warming up, and the backlight of the Standby /power button are flashing white.
3. When the backlight on the standby button are constant white, the projector are in standby mode, ready to
be switched on.
4. Press the standby button on the keypad or the power button on the remote to bring the projector up to on
mode.
The power button backlight on the keypad will flash blue while the projector is warming up.
5. When the power button backlight is steady blue, the projector is ready for use.

5.3 Power down the projector

Power down using the keypad or remote
1. Depress and hold the power button on the keypad or remote for four (4) seconds.
The Projector is now in cooling down phase.
2. Wait 2 minutes before disconnecting the power cord. (If disconnecting is required).
WARNING: There is a risk of reducing the expected lifetime of the projectors DMD device if the
power cord is removed too early, due to the device's shutdown sequence.

5.4 Power mode transitions

5.4.1 General

Transition Diagram
This diagram shows all modes available on the projector (unplug, ON, READY, ECO), and the actions
necessary to change mode.
ECO Powr
ON ON
JSON ASCII
Image 5–1
78 601–426 /15 F70 Series
ECO
Stby
ECO
ON
ON
ASCII
JSON
READY
ON
OFF
ON
ON
JSON
JSON
ON
1%
50%
50%