Oki OKIOFFICE 84 Service Manual page 98

Service Personnel Initial Settings Table 2.9.2 (6/7)
T.F. Item
No.
27 Head width
28 Media type
29 Transfer roller latch current
30 NSF switch
Copyright 1998, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business Partner
Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Service Guide OKIOFFICE 84
Chapter 2 Installation
Specifications
Head width
You should confirm the head width by the following
table, and then select it by this setting.
Head width is two types (TYPE1/TYPE2).
Selects the recording paper according to its
quality. Medium, Medium-heavy and Heavy
selectable.
Selects the latch current for transfer roller.
(-2/-1/0/+1/+2)
NSF signal transmission selectable.
ON: Transmits NSF signal
OFF: Disables NSF signal
Note:
When NSF switch = OFF, the fax operation
is shown as below.
l
When transmitting, even if OKI NSF signal is
detected from the remote machine, the fax
transmits DCS signal (The fax does not
transmit NSC signal.)
l
When Remote Diag. = ON, the fax transmits
NSF signal.
Page: 53
Default