Oki OKIOFFICE 84 Service Manual page 144

Table 2.9.4 (3/5) User's Initial Settings (Functions Program)
F+OT Item
No.
14 User language
15 Incoming ring
16 Remote receive
17 Memory and feeder switch
18 Power save mode
19 ECM function
Service Guide OKIOFFICE 84
Chapter 2 Installation
Specifications
A choice of 2 languages for LCD and print message
are available. GER, FRE etc. are displayed instead of
ANOTHER.
ENGL1/ANOTHER selectable.
Instead of ringer circuit, software can control built-in
speaker to ring sound.
To enable (ON) or disable (OFF) or distinctive ring
(DRC) a software generated ring sound to indicate
arrival of an incoming bell.
This function is used to transfer a call received by an
external telephone set (connected to fax) by entering
two-digit MF tones if the remote receive setting is not
OFF
The following combinations are selectable.
00/11/22/33/44/55/66/77/88/99/**/##/OFF selectable.
Switches the transmission mode between the memory
and feeder.
MEM. TX/FEEDER TX selectable.
Note:
This function becomes effective when Instant
Dial of No. 25 is set to OFF.
The power supply will be fed to all circuits of a fax
machine whenever the fax goes to the operating state.
The power save mode has reduced the power
consumption at standby to below 0.5 W.
Note:
Power save mode is not available for ODA
version. (including LTA, MEX)
Pre-heating time (Standby to print):
Approx 30 sec
Enables or disables power save mode
ON: Enables
OFF: Disables
Enables or disables ECM (error correction mode)
communication.
ON: Enables
OFF: Disables
Page: 79