Oki OKIOFFICE 84 Service Manual page 94

Service Personnel Initial Settings Table 2.9.2 (4/7)
T.F. Item
No.
16 T2, timeout value
17 DIS bit32
18 Error criterion
19 Off-hook bypass
20 NL equalizer
Service Guide OKIOFFICE 84
Chapter 2 Installation
Specifications
T2, timeout value (layer)
Registers the time duration (in seconds) for which
the receiving fax detects the EOL (End Of Line)
signal during phase C. The fax will disconnect the
line when EOL cannot be detected within T2.
* Selects the 3 digit timer 001 to 255 selectable.
(in 100ms steps)
For example: 060 x 100 ms =6 s
Selects whether a called fax should transmit DIS
bit 32 or not.
ON : Transmits DIS bit 32.
OFF: Does not transmit DIS bit 32.
(When OFF, the following functions will
not be supported:
l
Reception of Extra Fine (8´15.4 line/
mm)
l
300 dpi
l
SEP/SUB frames
Note:
To improve compatibility between this fax
machine and other company's fax machines.
If communication error occurs frequently
when a fax sender is an older version.
Registers the threshold value whether to transmit
RTN or MCF signal when the error occurs in
received data.
00% to 99% selectable. (in one percent steps)
Switches the function of maintaining
communication without hooking up the telephone
set in normal testing etc.
ON : Enable
OFF: Disable
Selects equalization for the following cable
lengths:
0 km/1.8 km/3.6 km/ 7.2 km selectable.
Note: Relative to 1700Hz for length of 0.4mm
diameter cable.
Equalizer level is the difference of gain of
equalized signal between 0.3kHz and
3.4kHz.
Page: 51
Default