Hopping Shaft Assembly - Oki OKIOFFICE 84 Service Manual

4.3.16 Hopping Shaft Assembly

1
Disassembly procedure
a) First, carry out procedure up to the point of the 4.3.2 (ID Unit, Cover-Rear, Cover-NCU and
Cover-MAIN).
b) Dismount the high-voltage power supply board. (See Section 4.3.10)
c) Dismount the paper holder assembly. (See Section 4.3.11)
d) Dismount the sheet guide. (See Section 4.3.12)
e) Dismount the side plate M. (See Section 4.3.12)
f) Raise up roller holder, slide hopping shaft assembly, and dismount roller holder and hopping roller.
(Knock pin also comes off at the same time. Take care not to lose it.)
g) Draw out hopping shaft assembly to the right and dismount magnet H.
2
Reassembly procedure
Reverse the disassembly procedures.
Copyright 1998, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business Partner
Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Service Guide OKIOFFICE 84
Chapter 4 Disassembly
Page: 127