Led Print Head - Oki OKIOFFICE 84 Service Manual

4.3.1 LED Print Head

Two LED print heads are available.. (208 mm (8.18 inch) width or 216 mm (8.5 inch) width)
1
Disassembly procedure
a) Open the cover assembly-top by raising the cover in the direction of the arrow.
b) Disconnect the PC connector from the LED print head.
c) Remove the LED head while spreading the left clamp on the cover assembly-top.
sure not to touch directly or push the SLA part of the print head.
2
Reassembly procedure
Reverse the disassembly procedures.
Note:
After replacing the LED print head, set drive time of the LED print head following the marking.
(Refer to section 5.1).
When you replace the LED print head, if the width of the LED head to be used is changed from current
version, you should select the head width by the service personnel initial setting. (Refer to Table 2.9.1 TF
No. 26 and 27)
Service Guide OKIOFFICE 84
Chapter 4 Disassembly
Page: 112
Note:
Be