Oki OKIOFFICE 84 Service Manual page 142

Table 2.9.4 (2/5) User's Initial Settings (Functions Program)
F+OT Item
No.
08 Closed network
09 TX mode default
10 Telephone/fax automatic
switchover time
11 Ring response time
12 Distinct ring
Service Guide OKIOFFICE 84
Chapter 2 Installation
Specifications
The fax compares lower four digits of TSI/CSI received
from remote station with fax numbers registered locally
for one-touch dial and two-digits autodial. If
unmatched, the communication will be automatically
disconnected.
OFF/RX only/TX and RX selectable.
* Prevention of direct mail or wrong number calls.
(Reference)
TSI: Transmitting subscriber identification
CSI: Called subscriber identification
Selects automatically the mode set up when a
document is loaded on the feeder.
The following combinations are selectable.
STD/NORMAL-->STD/DARK-->STD/LIGHT-->
FINE/NORMAL-->FINE/DARK-->FINE/LIGHT-->
EX.FINE/NORMAL-->EX.FINE/DARK-->
EX.FINE/LIGHT-->PHOTO/NORMAL-->
PHOTO/DARK-->PHOTO/LIGHT-->
STD/NORMAL-->***
Specifies the time for which the fax alerts an operator
on reception of a call in the telephone/fax automatic
switchover mode.
20 sec./35 sec. selectable
User can register ring response time if National code
is:
INT'L, GBR, NOR, SWE, USA, HOL, ESP. ITA,
GRE or GER
Selects the ring response time.
1 ring/5/10/15/20 sec. selectable.
Specifies the detected distinct ring. (not available in all
countries)
OFF/ON/SET selectable.
Page: 78