Oki OKIOFFICE 84 Service Manual page 92

Service Personnel Initial Settings Table 2.9.2 (3/7)
T.F. Item
No.
09 MDY/DMY
10 Long document SCAN
11 Tone for Echo
12 MH only
13 High-speed modem rate
14 T1 (TX), timeout value
15 T1 (RX), timeout value
Service Guide OKIOFFICE 84
Chapter 2 Installation
Specifications
Switches LCD display and report print from
month/day/year to day/month/year or vice versa.
MDY/DMY selectable.
Switches the function of transmitting long-size
document (more than 360 mm).
ON : 1500 mm or 60 min.
OFF : 360 mm or 60 min.
Note: 60 min is transmitting time.
Switches the function to apply to poor lines with
echo in overseas transmission, etc.
ON: Enables
OFF: Disables
Switches the function of limiting image
compression to the MH codes only.
ON : Coding scheme is MH only. When the
receiving image data is affected by noise on
the telephone line.
OFF : Any of MH, MR and MMR.
Specifies the modem's starting speed, 14.4k, 9.6k,
or 4.8kbps.
T1 (TX) is a time to detect up to 3 flags of DIS sent
from a called fax machine.
Registers the time duration (in seconds) for which
the fax waits for the remote station's answer.
This timer starts when the last dialed digit has
been sent in the automatic transmission mode.
* Selects the 3 digit timer 010 to 255 sec
selectable. (in one second steps)
T1 (RX), timeout value (later)
Registers the time duration (in seconds) for which
the fax waits for the remote station's answer of
individual country's specification. This timer starts
after the DIS is transmitted. If T1 times out, the fax
disconnects the line.
* Selects the 3 digit timer 010 to 255 sec
selectable. (in one second steps)
Page: 50
Default