Oki OKIOFFICE 84 Service Manual page 146

Table 2.9.4 (4/5) User's Initial Settings (Functions Program)
F+OT Item
No.
21 PC/FAX switch
22 No toner memory reception (NO
Toner MEM RX)
23 Memory full save (MEM Full
Save)
24 Continuous Tone
25 Instant Dialing
Service Guide OKIOFFICE 84
Chapter 2 Installation
Specifications
To enable or disable PC interface function.
When PC reception is not available, for example,
application is not activated on the PC or cable is
missing between PC and fax etc., this setting allows to
switch from PC to fax reception automatically.
ON: Automatically change to fax reception
OFF: No reception
Enables or disables the memory reception when the
fax is the toner low condition.
ON: Receives the message in the memory
reception when the fax is the toner low
condition. The messages are printed when
toner has been newly supplied.
OFF: Prints the message even the remaining toner
level is low or none. Print quality is not
guaranteed.
Broadcast transmission and other features originate
calls after all the document read in memory. When
Memory Full occurs during reading documents and
operator time out occur, all the readout data must be
deleted (OFF setting) or all the data must be sent (ON
setting).
Select either ON or OFF setting as follows:
ON: Selecting display
OFF: Selecting delete at all times.
Note:
Operator timeout means operator does not
respond during 59 seconds.
Setting of sounding warning tone after reception.
ON: Warning tone sounding stops by operator's
STOP key pressing
OFF: No warning tone
Setting to start reading documents upon call
origination when transmitting.
ON: Dialing while document scanning
OFF: Dialing after document scanning
Page: 80