Oki OKIOFFICE 84 Service Manual page 96

Service Personnel Initial Settings Table 2.9.2 (5/7)
T.F. Item
No.
22 T/F tone attenuator
(for TEL/FAX SW)T
23 MF attenuator
24 Ring duration detection time
25 CML timing
Service Guide OKIOFFICE 84
Chapter 2 Installation
Specifications
Note:
The send signal power level should meet
your country's regulation. Some countries may
specify the power level at a telephone exchange.
In that case, you should substract the specified
level from the line cable attenuation to determine
the send level of your fax.
Adjusts the attenuation (dB) for the quasi-ring
back tone send signal of TEL/FAX switching.
Adjusting value is 0 to 15 dB in one dB steps.
Adjusts the attenuation (dB) for the send MF tone
power level.
Adjusting value is 0 to 15 dB in one dB steps.
Selects the minimum ring detection time to meet
country's requirements.
Adjusting time is 100 MS to 990 MS in 10 MS
steps.
10 to 99 selectable.
For example: (120 ms)
12 x 10 ms = 120 ms
Selects the time from end of ring to CML-ON.
Adjusting time is 100 MS to 1900 MS in 100 MS
steps.
0 to 19 selectable.
For example: (300 ms)
03 x 100 ms = 300 ms
Page: 52
Default