Reel Assembly Removal And Installation - Toro Reelmaster 5210 Service Manual

Reel Assembly Removal and Installation

22
15
16
RIGHT
FRONT
1. Bedbar assembly
2. Rubber bushing (2 used)
3. Flange bushing (2 used)
4. Plastic washer (4 used)
5. Metal washer (2 used)
6. Bedbar pivot bolt (2 used)
7. Lock nut (2 used)
8. Shoulder bolt (3 used per side plate)
NOTE: This section provides the procedure for remov-
ing and installing the cutting reel assembly (cutting reel,
spline inserts, grease seals and bearings) from the cut-
ting unit.
NOTE: Refer to Reel Assembly Service later in this sec-
tion for information on replacing cutting reel grease
seals, bearings and spline inserts.
Cutting Units (Rev. C)
12
24
13
14
17
18
See text for
tightening
procedure
Loctite #242
12 to 15 in- -lb
(1.4 to 1.7 N- -m)
Figure 26
9. LH side plate
10. Weight
11. Cap screw (2 used)
12. O- -ring
13. Cutting reel
14. Spline insert (LH thread)
15. RH side plate
16. Spline insert (RH thread)
Page 7 - - 22
23
Grease OD surface
19
20
21
12
Grease bore
and threads
27 to 33 ft- -lb
(37 to 44 N- -m)
NOTE: Removal of the cutting reel requires removal of
the left side plate from the cutting unit frame. The right
side plate does not have to be removed from the frame.
7" CUTTING REEL SHOWN
1
27 to 33 ft- -lb
(37 to 44 N- -m)
9
8
4
2
3
4
Antiseize
Lubricant
11
10
17. Retaining ring (2 used)
18. Grease seal (2 used)
19. Bearing (2 used)
20. Bearing adjuster nut
21. Set screw
22. Cap screw (2 used)
23. Cutting unit frame
24. Flange nut (3 used per side plate)
Reelmaster 5010 Series
5
6
7