Reel Assembly Removal And Installation - Toro Greensmaster TriFlex 3300 Service Manual

Reel Assembly Removal and Installation

8
12
10
11
3
7
Grease OD
surface
RIGHT
FRONT
1. Crossmember
2. LH side plate
3. Washer head screw (2 used)
4. Shoulder bolt (2 used per side plate)
5. Flange nut (2 used per side plate)
6. Cutting reel assembly
NOTE: This section provides the procedure for remov-
ing and installing the cutting reel assembly (cutting reel,
flocked seals, reel bearings, bearing lock screw and reel
nut) from the cutting unit. Refer to Reel Assembly Ser-
vice later in this section for information on servicing the
cutting reel assembly.
DPA Cutting Units
210 to 240 in- -lb
(24 to 27 N- -m)
4
9
5
15
6
Grease OD
surface
7. Pitch arm (2 used)
8. Cap screw (2 used)
9. RH side plate
10. Weight
11. Hex nut (4 used)
12. O- -ring
13
5
5
3
7
Figure 22
NOTE: Removal of the cutting reel requires removal of
the LH side plate from the cutting unit crossmember.
The RH side plate does not have to be removed from the
frame when using the following procedure.
Page 8 - - 20
210 to 240 in- -lb
(24 to 27 N- -m)
1
5
2
14
11
16
17
18
13. Grass shield
14. Flat wire spring
15. Crosslink
16. Reel motor adapter
17. Socket head screw (2 used)
18. Motor clamp
Greensmaster 3300/3400
4