Motorola WiNG 5.4.2 System Reference Manual page 88

5 - 22 WiNG 5.4.2 Access Point System Reference Guide
9. Set the following network information from within the
Enable Zero
Configuration
Primary IP Address
Use DHCP to Obtain IP
Use DHCP to obtain
Gateway/DNS Servers
Secondary Addresses
10. Define the Network Address Translation
Select either the Inside, Outside or None radio buttons.
• Inside - The inside network is transmitting data over the network its intended destination. On the way out, the source IP
address is changed in the header and replaced by the (public) IP address.
• Outside - Packets passing through the NAT on the way back to the LAN are searched against to the records kept by the
NAT engine. There the destination IP address is changed back to the specific internal private class IP address in order to
reach the LAN over the network.
• None - No NAT activity takes place. This is the default setting.
11. Select OK button to save the changes to the Basic Configuration screen. Select
configuration.
12. Select the Security
The access point can use Zero Config for IP assignments on an individual virtual interface
basis. Select Primary to use Zero Config as the designated means of providing an IP
address, this eliminates the means to assign one manually. Selecting Secondary is
preferred when wanting the option to either use Zero Config or manual assignments.
Define the IP address for the VLAN associated Virtual Interface.
Select this option to allow DHCP to provide the IP address for the Virtual Interface.
Selecting this option disables the Primary IP address field.
Select this option to allow DHCP to obtain a default gateway address, and DNS resource
for one virtual interface. This setting is disabled by default and only available when the
Use DHCP to Obtain IP option is selected.
Use the Secondary Addresses parameter to define additional IP addresses to associate
with VLAN IDs. The address provided in this field is used if the primary IP address is
unreachable.
(NAT) direction.
tab.
IP Addresses field:
Reset to revert to the last saved