Motorola WiNG 5.4.2 System Reference Manual page 202

5 - 136 WiNG 5.4.2 Access Point System Reference Guide
3. Define the following Device Heartbeat Settings in respect to devices supported by the controller profile:
Designated IS Priority
Adjustment
4. Select the Latency of Routing Recalculation
spinner control used for defining a latency period from 0 - 60 seconds. The default setting has the check box disabled.
5. Define the following MINT Link Settings in respect to devices supported by the controller profile:
MLCP IP
MLCP VLAN
Tunnel MiNT across
extended VLAN
6. Select the Tunnel Controller Load Balancing (Level1)
7. Define the group name of clustered tunnel controllers in the
8. Select OK to save the changes made to the
9. Select the IP
MINT configuration. The
time settings used by managed devices to securely communicate amongst one another within the IPSec network.
Use the spinner control to set a Designated IS Priority Adjustment setting from -255
and 255. This is the value added to the base level DIS priority to influence the
Designated IS (DIS) election. A value of +1 or greater increases DISiness. The default
setting is 0.
Select this option to enable MINT Link Creation Protocol (MLCP) by IP Address. MLCP
by IP is used to create one UDP/IP link from the device to a neighbor. The neighboring
device does not need to be a Virtual Controller, it can be an standalone access point.
Select this option to enable MLCP by VLAN. MLCP by VLAN is used to create one
VLAN link from the device to a neighbor. The neighboring device does not need to be
a Virtual Controller, it can be an standalone access point.
Select this option to enable tunneling MiNT protocol packets across extended VLANs.
tab to display the link IP network address information shared by the devices managed by the access point's
IP tab displays the IP address, routing level, link cost, hello packet interval and adjacency hold
Figure 5-84 Advanced Profile Configuration - MINT Protocol screen - IP tab
check box (within the Shortest Path First (SPF)
check box to enable load balancing on the tunnel controller.
Preferred Tunnel Controller Name
Settings tab. Select Reset
field) to enable the
field.
to revert to the last saved configuration.