Motorola WiNG 5.4.2 System Reference Manual page 456

6 - 100 WiNG 5.4.2 Access Point System Reference Guide
Mesh Rx Rate Limit
Neighbor Tx Rate Limit
Neighbor Rx Rate Limit
Classification
5. Select the Add
its existing configuration. Existing QoS policies can be selected and deleted as needed.
The Rate Limit
Excessive traffic can cause performance issues or bring down the network completely. Excessive traffic can be caused by
numerous sources including network loops, faulty devices or malicious software such as a worm or virus that has infected
on one or more devices at the branch. Rate limiting limits the maximum rate sent to or received from the wireless network
(and Mesh Point) per neighbor. It prevents any single user from overwhelming the wireless network. It can also provide
differential service for service providers. An administrator can set separate QoS rate limit configurations for data
transmitted from the managed network and data transmitted from a Mesh Point's neighbor back to their associated access
point radios and controller.
Before defining rate limit thresholds for Mesh Point transmit and receive traffic, Motorola Solutions recommends you
define the normal number of ARP, broadcast, multicast and unknown unicast packets that typically transmit and receive
from each supported WMM access category. If thresholds are defined too low, normal network traffic (required by end-user
devices) will be dropped resulting in intermittent outages and performance problems.
A connected neighbor can also have QoS rate limit settings defined in both the transmit and receive direction.
Displays whether or not a Mesh Rx Rate Limit is enabled for each Mesh QoS policy. When
the rate limit is enabled a green check mark is displayed, when it is disabled a red X is
displayed.
Displays whether a NeighborTx Rate Limit is enabled for each Mesh QoS policy. When the
rate limit is enabled a green check mark is displayed, when it is disabled a red X is
displayed.
Displays whether a NeighborRx Rate Limit is enabled for each Mesh QoS policy. When the
rate limit is enabled a green check mark is displayed, when it is disabled a red X is
displayed.
Displays the forwarding QoS classification for each Mesh QoS policy.
button to define a new Mesh QoS policy, or select an existing Mesh QoS policy and select
screen displays by default for the new or modified QoS policy.
Edit to modify