Motorola WiNG 5.4.2 System Reference Manual page 292

5 - 226 WiNG 5.4.2 Access Point System Reference Guide
3. Select Profile Overrides
4. Select Network
5. Select Routing.
6. Select the IP Routing
default.
7. Select the Policy Based Routing
click the Edit
see Policy Based Routing (PBR) on page
8. Select Add Row +
9. Add IP addresses and network masks in the Network column.
10. Provide the Gateway used to route traffic.
11. Refer to the Default Route Priority field and set the following parameters:
Static Default Route
Priority
DHCP Client Default Route
Priority
from the Device menu to expand it into sub menu options.
to expand its sub menu options.
Figure 5-138 Profile Overrides - Network - Network Routing screen
option to enable IP routing using static routes provided in the route table. This option is enabled by
policy to apply to this profile. Click the
to edit an existing policy after selecting it in the drop-down list. For more information on policy based routing,
7-2.
as needed to include single rows with in the static IPv4 route table.
Use the spinner control to set the priority value (1 - 8,000) for the default static route.
The default setting is 100.
Use the spinner control to set the priority value (1 - 8,000) for the default route learnt
from the DHCP client. The default setting is 1000.
Create icon to create a policy based route or