Motorola WiNG 5.4.2 System Reference Manual page 278

5 - 212 WiNG 5.4.2 Access Point System Reference Guide
5. Select L2TP V3.
NOTE: A blue override icon (to the left of a parameter) defines the parameter as having
an override applied. To remove an override, go to the Basic Configuration screen's Device
Overrides field and select Clear Overrides. This will remove all overrides from the device.
6. Set the following General Settings for an L2TPv3 profile configuration:
Host Name
Router ID
UDP Listen Port
Device Type
7. Select the L2TP Tunnel
Figure 5-129 Profile Overrides - Network - L2TPv3 screen, General tab
Define a 64 character maximum host name to specify the name of the host that's sent
tunnel messages. Tunnel establishment involves exchanging 3 message types (SCCRQ,
SCCRP and SCCN) with the peer. Tunnel IDs and capabilities are exchanged during the
tunnel establishment with the host.
Set either the numeric IP address or the integer used as an identifier for tunnel AVP
messages. AVP messages assist in the identification of a tunnelled peer.
Select this option to set the port used for listening to incoming traffic. Select a port from
1,024 - 65,353.
Select this option to enable or disable bridge packets between two tunnel end points. This
setting is disabled by default.
tab.