Table of Contents
Advertisement
9. Refer to the
Select Authentication
Security Mode
10. Set the following
Key Settings
Pre-Shared Key
11. Set the following
Key Rotation
Unicast Rotation Interval
Broadcast Rotation
Interval
12. Select
OK
to save the changes made to the configuration. Select
13. Select the
Radio Rates
Figure 6-44 MeshConnex - Security screen
field to define an authentication method for the mesh policy.
Select a security authentication mode for the mesh-point. Select none to set no
authentication for the mesh point. Select psk to set a pre-shared key as the authentication
for the mesh-point. If psk is selected enter a pre-shared key in the Key Settings field.
for the mesh point:
When the security mode is set as psk, enter a 64 character HEX or an 8-63 ASCII character
passphrase used for authentication on the mesh point.
for the mesh point:
Define an interval for unicast key transmission in seconds (30 - 86,400).
When enabled, the key indices used for encrypting/decrypting broadcast traffic will be
alternatively rotated based on the defined interval Define an interval for broadcast key
transmission in seconds (30 - 86,400). Key rotation enhances the broadcast traffic security
on the WLAN.
tab.
Reset
to revert to the last saved configuration.
6 - 95
Hide quick links:
Advertisement
Table of Contents
