Motorola WiNG 5.4.2 System Reference Manual page 315

3. Define the following:
Tunnel Name
Tunnel Type
Interface
Traffic Selector
4. Click the Next button to go to Step 2.
Figure 5-155 VPN Step-By-Step Wizard - Step 1
Provide a name for the tunnel in the
Select the tunnel type being created. Two types of tunnels can be created.
to create a tunnel between two remote sites as indicated in the image.
used to create a tunnel between an user device and a network as indicated in the image.
Select the interface to use. Interface can be a Virtual LAN (VLAN) or WWAN or PPPoE
depending on the interfaces available on the device.
This field creates the Access Control List (ACL) that is used to control who uses the network.
Provide the Source and Destination
Rule button to add the rule into the ACL.
Tunnel Name field.
IP address ranges with their net mask. Click the
5 - 249
Site to Site is used
Remote Access is
Add