Motorola WiNG 5.4.2 System Reference Manual page 703

The Root tab displays the following:
Mesh Point Name
Recommended
Root MPID
Next Hop IFID
Radio Interface
Bound
Metric
Interface Bias
Neighbor Bias
Root Bias
The Multicast Path tab displays the following:
Mesh Point Name
MP ID
Member Address
Group Address
Path Timeout
The Neighbors tab displays the following:
Mesh Point Name
MP ID
Neighbor MP ID
Neighbor IFID
Root MP ID
Displays the name of each configured Mesh Point.
Displays the root that is recommended by the mesh routing layer.
The MP identifier is used to distinguish between other Mesh Points both on the same
device and on other devices. This is used by a user to setup the preferred root
configuration.
The IFID of the next hop. The IFID is the MAC Address on the destination device.
This indicates the interface that is used by the device to communicate with this neighbor.
The values are 2.4 and 5.8, indicating the frequency of the radio that is used to
communicate with the neighbor.
Indicates whether the root is bound or unbound.
Displays the computed path metric between the neighbor and their Root Mesh Point.
This field lists any bias applied because of the Preferred Root Interface Index.
This field lists any bias applied because of the Preferred Root Next-Hop Neighbor IFID.
This field lists any bias applied because of the Preferred Root MPID.
Displays the name of each configured Mesh Point.
The MP identifier is used to distinguish between other Mesh Points both on the same
device and on other devices. This is used by a user to setup the preferred root
configuration.
Displays the MAC address used for the members in the Mesh Point.
Displays the MAC address used for the Group in the Mesh Point.
The timeout interval in seconds. The interpretation this value will vary depending on the
value of the state. If the state is Init or In Progress, the timeout duration has no
significance. If the state is Enabled, the timeout duration indicates the amount of time left
before the security validity check is initiated. If the state is Failed, the timeout duration is
the amount of time after which the system will retry.
Displays the name of each configured Mesh Point in the mesh network.
Displays the MeshID (MAC Address) of each Mesh Point in the mesh network.
The MAC Address that the device uses to define the Mesh Point in the device that the
neighbor is a part of. It is used to distinguish the device that is the neighbor.
The MAC Address used by the interface on the neighbor device to communicate with this
device. This may define a particular radio or Ethernet port that communicates with this
device over the mesh.
The MAC Address of the neighbor's Root Mesh Point.
13 - 77