Motorola WiNG 5.4.2 System Reference Manual page 350

5 - 284 WiNG 5.4.2 Access Point System Reference Guide
Adjacency Hold Time
IPSec Secure
IPSec GW
27. Select the VLAN
configuration.
The VLAN tab displays the VLAN, Routing Level, Link Cost, Hello Packet Interval and Adjacency Hold Time managed devices
use to securely communicate amongst one another.
28. Select Add to create a new VLAN link configuration or
NOTE: If creating a mesh link between two access points in Standalone AP mode, you'll
need to ensure a VLAN is available to provide the necessary MINT link between the two
Standalone APs.
Set or override a hold time interval in either Seconds (2 - 600) or Minutes
(1 - 10) for the transmission of hello packets. The default interval is 46 seconds.
Select this option to use a secure link for IPSec traffic. This setting is disabled by
default. When enabled, both the header and the traffic payload are encrypted.
Define either an IP address or hostname for the IPSec gateway.
tab to display the link IP VLAN information shared by the access points managed by the MINT
Figure 5-183 Profile Overrides - Advanced Profile MINT screen - VLAN tab
Edit to override an existing MINT configuration.