Network Deployment Considerations - Motorola WiNG 5.4.2 System Reference Manual

Reconnect Attempts
Reconnect Interval
Retry Count
Retry Time Out
Rx Window Size
Tx Window Size
Failover Delay
Force L2 Path
Recovery
6. Select OK to save the updates to the L2TP V3 Policy Details. Select

7.3 Network Deployment Considerations

Before defining an access point network configuration, refer to the following deployment guidelines to ensure the configuration
is optimally effective:
• In respect to L2TP V3, data transfers on the pseudowire can start as soon as session establishment corresponding to the
pseudowire is complete.
• In respect to L2TP V3, the control connection keep-alive mechanism of L2TP V3 can serve as a monitoring mechanism for
the pseudowires associated with a control connection.
Use the spinner control to set a value (from 0 - 250) representing the maximum number of
reconnection attempts initiated to reestablish the tunnel. The default interval is 5.
Define an interval in either Seconds (1 - 3,600), Minutes (1 -60) or Hours (1) between two
successive reconnection attempts. The default setting is 2 minutes.
Use the spinner control to define how many retransmission attempts are made before
determining a target tunnel peer is not reachable. The available range is from 1 - 10, with a
default value of 5.
Use the spinner control to define the interval (in seconds) before initiating a retransmission
of a L2TP V3 signaling message. The available range is from 1 - 250, with a default value of 5.
Specify the number of packets that can be received without sending an acknowledgement.
The available range is from 1 - 15, with a default setting of 10.
Specify the number of packets that can be transmitted without receiving an
acknowledgement. The available range is from 1 - 15, with a default setting of 10.
Specify the number of seconds to delay reestablishing a failed tunnel.The available duration
is 5 - 60 seconds or 1 minute.
Select to enable forcing the discovery of servers, gateways and other networks behind a
L2TPV3 tunnel when a tunnel is being established or when a failed tunnel is being
reestablished.
Reset to revert to the last saved configuration.
7 - 11