Motorola WiNG 5.4.2 System Reference Manual page 186

5 - 120 WiNG 5.4.2 Access Point System Reference Guide
The screen lists the destination IP addresses or interfaces (VLAN, WWAN, or PPPoE) used for critical resource connection.
IP addresses can be monitored directly by the access point or controller, whereas a VLAN, WWAN or PPPoE must be
monitored behind an interface.
5. Select the Add
existing resource and select
6. Use the Offline Resource Detection
Options include Any and All. If selecting Any, an event is generated when the state of any single critical resource changes.
If selecting All, an event is generated when the state of all monitored critical resources change.
7. Select the IP check box (within the
the same subnet) using the provided critical resource IP address as a network identifier.
8. Select the Interface
either the critical resource's VLAN, WWAN1 or PPPoE1 interface. If VLAN is selected, a spinner control is enabled to define
the destination VLAN ID used as the interface for the critical resource.
9. Select + Add Row
IP Address
button at the bottom of the screen to add a new critical resource and connection method, or select and
Edit to update the resource's configuration.
Figure 5-76 Critical Resources screen - Adding a Critical Resource
drop-down menu to define how critical resource event messages are generated.
Monitor Via
check box (within the Monitor Via
to define the following for critical resource configurations:
Provide the IP address of the critical resource. This is the address used by the access point to ensure
the critical resource is available. Up to four addresses can be defined.
field at the top of the screen) to monitor a critical resource directly (within
field at the top of the screen) to monitor a critical resource using