Motorola WiNG 5.4.2 System Reference Manual page 46

3 - 10 WiNG 5.4.2 Access Point System Reference Guide
available ports differ depending on the access point model deployed. Access point models with a single port have this
option selected and disabled.
• Enable NAT on the WAN Interface
and LAN interfaces.
8. Select Next. The Initial Setup Wizard displays the
radio band, 5.0 GHz radio band or to set the radio's functionality as a dedicated sensor.
NOTE: The Radio Configuration screen displays separate configurable fields for each
access point radio. Supported access point models can have from one to three (AP7131)
radios. The ADSP Sensor Server field displays at the bottom of the screen only if a radio
has been dedicated as a sensor.
9. Set the following parameters for each radio:
• Configure as a Data Radio
2.4 GHz or 5.0 GHz radio band.
• Radio Frequency Band
- Select the checkbox to allow traffic to pass between the access point's WAN
Radio Configuration
Figure 3-9 Initial Setup Wizard - Radio Configuration screen
- Select this option to dedicate this radio for WLAN client support in either the selected
- Select either the 2.4 GHz or 5.0 GHz radio band to use with the radio when selected as a Data
screen to define radio support for the 2.4 GHz