Configuration - Virtual Server - Dynamix UM-A User Manual

4.3.2.5 Configuration – Virtual Server
Virtual Servers are used for port forwarding from the WAN to LAN networks.
The Virtual Server Configuration page allows you to set the configuration of the Virtual Server. All
UDP/TCP ports are protected from intrusion. If any specific local PCs need to be mapped to the
UDP/TCP port on WAN side, please input the mappings here.
Note :There can be up to 20 different Virtual Server Configurations.
ID: This is the ID number corresponding to the Virtual Server configuration.
Public Port - Start: This field allows you to enter the port number of the Public Network
(WAN or external network). If you are entering a range of ports, this is the first port.
Public Port - End: This field represents the last port number in a port range. If you only want
one port number (no port range), simply enter the same number here as in the
Public Port – Start field.
Note : The maximum number of the mapped Port is 20.
Private Port: This field allows you to enter the port number of the Private Network (LAN or
internal network). In most cases, the private port number is same as public port number. This
port number cannot be seen from the WAN side.
Host IP Address: This field allows you to enter the private network IP address for the
particular server. Well-known TCP/IP ports are listed in Table below:
4/1 Port ADSL Router P 69