Dynamix UM-A User Manual page 116

Note: The Outbound Policy works in a Top-Down fashion according to the Outbound Policy
Table. This means that the firewall will apply the policies in order from the top of the table to
the bottom. It is critical for both security and user accessibility to the WAN to have outbound
policies in the correct order. See Section below for an example of this.
Edit: Clicking this button will display a table similar to the add table (see next page) to the
bottom of the policy table that will allow you to modify the corresponding policy.
Delete: This will delete the corresponding policy.
Add Inbound Policy: Clicking on this button will bring up a table with all the add
configurations as shown below:
Src IP: This specifies the Source IP for the Outbound Policy. This is the internal (LAN side,
behind the firewall) IP address or addresses and Subnet Mask(s) that will be affected by the
policy. In this field there are two IP Address entry fields and a dropdown menu. The
dropdown menu has four options:
Any IP: Selecting this will cause all IPs to be affected by the policy. When this is
selected, you will be unable to enter any information into the IP Address entry
fields.
Single IP: Selecting this will cause only one IP Address to be affected by the
policy. This IP Address will need to be specified by the user in the first IP Address
entry field.
4/1 Port ADSL Router P 115