Configuration-Nat - Dynamix UM-A User Manual

4.3.2.4 Configuration—NAT
The NAT Configuration page allows you to set the configuration for the Network Address Translation.
The NAT module provides Dynamic Network Address and Port Translation (Dynamic NAPT)
capability between LAN and multiple WAN connections, and the LAN traffic is routed to appropriate
WAN connections based on the destination IP addresses and the Route Table. This eliminates the need
for the static NAT session configuration between multiple LAN clients and multiple WAN
connections.
When Dynamic NAPT is chosen (default), there is no need to configure the NAT Session and NAT
Session Name Configuration.
I. NAT Configuration :
NAT: Use this field to Enable/Disable NAT. Default is Enable.
Mode: Options for the NAT dropdown menu are:
NAT: Static peer-to-peer mode (1x1).
NAPT: Static multiple mapping mode (1xN).
Dynamic NAPT: Dynamic multiple mapping mode (NxN). This is the default
setting.
4/1 Port ADSL Router P 67