Dynamix UM-A User Manual page 112

Note: The Inbound Policy works in a Top-Down fashion according to the Inbound Policy
Table. This means that the firewall will apply the policies in order from the top of the table to
the bottom. It is critical for both security and user accessibility to the WAN to have inbound
policies in the correct order. See Section next section for an example of this.
Edit: Clicking this button will display a table similar to the add table (see below) to the
bottom of the policy table that will allow you to modify the corresponding policy.
Delete: This will delete the corresponding policy.
Add Inbound Policy: Clicking this button will bring up a table with all the add configurations
as shown below:
Src IP: This specifies the Source IP for the Inbound Policy. This is the external (WAN side,
outside of the firewall) IP address or addresses and Subnet Masks that will be affected by the
policy. In this field there are two IP Address entry fields and a dropdown menu. The
dropdown menu has four options:
Any IP: Selecting this will cause all IPs to be affected by the policy. When this is
selected, you will be unable to enter any information into the IP Address entry
fields.
Single IP: Selecting this will cause only one IP Address to be affected by the
policy. This IP Address will need to be specified by the user in the first IP Address
entry field.
4/1 Port ADSL Router P 111