Dynamix UM-A User Manual page 96

I. Checking LAN Connection :
Testing Ethernet LAN Connection: This test passes if the Ethernet LAN interface is
working properly.
II. Checking ADSL Connection :
Testing ADSL Synchronization: This test checks your ADSL Router to see if it can
successfully negotiate and establish an ADSL connection with your service provider. The test
returns PASS if an ADSL connection is established.
If this test returns FAIL, please try the test again a few minutes after this test is completed.
Your ADSL Router needs up to one minute to establish the ADSL connection depending on
your phone line quality. If this test returns FAIL, make sure your phone line is connected to
your ADSL Router secured, and also check with your service provider to see if your service
is activated.
If this test returns FAIL, all other tests will be skipped.
III. Checking Circuit 0 For Network Connection :
Test ATM OAM Segment Loop Back: This test sends ATM OAM F5 Segment loop back
request cells to the CO. This test will pass if a response cell is received. Since some service
providers might not support this test, it could still work even if this test fails. If this test fails
consistently and the ADSL Router seems not working, make sure the VPI and VCI are
configured correctly.
This test returns FAIL if the ADSL synchronization test failed.
Test ATM OAM End-to-End Loop Back: This test sends ATM OAM F5 End to End loop
back request cells to the central office equipment through your ADSL connection. This test
returns PASS if response cell is received. Since your service provider might not support this
test, your ADSL Router could still be working properly even if this test fails.
If this test returns FAIL consistently and your ADSL Router seems to not be working, check
to make sure the VPI and VCI are configured correctly.
This test returns SKIPPED if the ADSL synchronization test failed.
Test Ethernet Connect to ATM: This test returns PASS if the ATM AAL5 module is
loaded correctly in your ADSL Router. If this test returns FAIL, an internal error has
occurred.
This test returns SKIPPED if the ADSL synchronization does not return PASS.
Test PPPoE Connection: This test returns PASS if your ADSL Router can see the PPPoE
server.
If this test returns FAIL, run this test again a few minutes after this test is completed,
especially if your PPPOE connection has just been improperly disconnected.
If this test consistently returns FAIL, make sure that the PPPoE settings are in the correct
configuration as instructed by your service provider, make sure the VPI and the VCI settings
4/1 Port ADSL Router P 95