Status - Ppp - Dynamix UM-A User Manual

4.3.1.2 Status – PPP
The PPP Status page shows the status of each PPP session for each PPP interface. This page contains
information that is dynamic and will refresh every 8 seconds.
Note: PPP interfaces can be created, modified, and deleted in the PPP Configuration page.
PPP (Point-to-Point Protocol): The table displays the following fields:
Connection Name: This is user defined. User defined connections for PPP can be created in
PPP Configuration page.
Interface: States the interface that is being used (PVC0 ... PVC7).
Mode: There are two available modes for the connection:
PPP over Ethernet (PPPoE)
PPP over ATM (PPPoA)
Status: States whether PPP connection is Connected or Not Connected.
Packets Sent: Number of packets sent by a particular PPP Connection.
Packets Received: Number of packets received by a particular PPP Connection.
Bytes Sent: Number of bytes sent by a particular PPP Connection.
Bytes Received: Number bytes received by a particular PPP Connection.
Connect and Disconnect: This field allows you to manually connect/disconnect the PPP
connection for each PPP interface. In other words, each PPP session can be connected and
disconnected individually.
Connection #: Specifies the PPP session to be connected/disconnected.
Connect/Disconnect Execute: Press this button to either connect or disconnect. Connection
status dialog will be displayed below the Execute button after it is pressed. Sample dialog
with explanation:
4/1 Port ADSL Router P 44